show voip interface

This command displays information (basic configuration, status and Performance Monitoring) of a specified telephony interface.

Syntax

show voip interface {e1-t1|bri|fxs-fxo} <Module>/<Port>

Command	Description
e1-t1	Displays information on a specified E1/T1 interface.
bri	Displays information on a specified BRI interface.
fxs-fxo	Displays the current status, main PM parameters and main configuration parameters to a specific analog interface (FXS or FXO).
module	Defines the module slot index as shown on the front panel
port	Defines the module's analog port number (FXS/FXO) or trunk port number (E1/T1 or BRI) to display.

Command Mode

Basic and Privileged User

Note

■

Parameters displayed depend on the PSTN protocol type.

■

The command is applicable to devices supporting analog and/or digital PSTN interfaces.

Example

This example displays information of the E1/T1 interface of trunk port 1 of trunk module 3on the BRI interface:

show voip interface e1-t1 3/1
 show voip interface e1-t1 3/1
-------------------------------
module/port:       3/1
trunk number:      0
protocol:          t1_transparent
state:             not active
alarm status:      LOS 1,  LOF 0,  RAI 0,  AIS 0,  RAI_CRC 0
loopback status:   no loop
send alarm status: no alarm
main performance monitoring counters collected in the last 470 seconds:
       BitError:           0           EBitErrorDetected:      0
       CRCErrorReceived:   0           LineCodeViolation:      0
       ControlledSlip:     0           ControlledSlipSeconds:  0
       ErroredSeconds:     0           BurstyErroredSeconds:   0
       UnAvailableSeconds: 470         PathCodingViolation:    0
       LineErroredSeconds: 0           SeverelyErroredSeconds: 0
       SeverelyErroredFramingSeconds: 0
 
    basic configuration:
       framing:        T1_FRAMING_ESF_CRC6
       line-code:      B8ZS
       clock-master:   CLOCK_MASTER_OFF
       clock-priority: 0
       trace-level:    no-trace

# show voip interface bri

 show voip interface bri 2/1
-----------------------------
       module/port:       2/1
       trunk number:      0
       protocol:          none
       state:             not active
       alarm status:      LOS 1,  LOF 0
       loopback status:   no loop

    performance monitoring was not started on this trunk.

    basic configuration:
       isdn-layer2-mode: BRI_L2_MODE_P2P
       trace-level:      no-trace

 show voip interface bri 2/2
-----------------------------
       module/port:       2/2
       trunk number:      1
       protocol:          none
       state:             not active
       alarm status:      LOS 1,  LOF 0
       loopback status:   no loop

    performance monitoring was not started on this trunk.

    basic configuration:
       isdn-layer2-mode: BRI_L2_MODE_P2P
       trace-level:      no-trace